connected to +5 and ground) the Common contact and Normally Open are closed. With current flowing through the coil (ie. With no current through the coil the Common contact and Normally Closed contact are closed. Top right and bottom right are the Common contactīottom middle is the other side of the coil With your relay sitting pins up in front of you as shown in the diagram with the group of four pins to your left. If you have a part number for the new relay, try looking for a datasheet from the manufacturer which may give better details.įailing that, use a multimeter to check for resistance/continuity on the pins and verify which pins are wired to the coil.The following applies only to the Multicomp datasheet you provided, your relay may be different. the coil is between pins 1 and 10 in the first two diagrams while in the third diagram you can latch it one way using pins 6 and 10, and latch it the other way using pins 5 and 1.) I am interpreting the three symbols on your new relay as variations because the coil is shown as being connected to different pins.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |